How do I set up the days, rooms and hours before I build the programme?

Prepare the frame of your programme: the days, the rooms with their capacity and screen, the hours of the grid, and the breaks.

Article Image Alt

The frame comes first

The Agenda Builder shows a grid: one tab per day, one column per room, and the hours down the side. Before you place a single talk, set up this frame. The talks then fall into a structure that matches your venue.

Step 1: Check the days

The days of the grid are the days of your event. Every date from the start to the end of the event becomes a day tab.

  1. On your event home, open Event setup.
  2. Check Event starts on and Event ends on.

Every date in between is a day of the grid; you cannot leave out a day in the middle. If your congress has a day without programme, leave that day empty.

Step 2: Create the rooms

  1. Open Content And Speakers and, under Configure, choose Room Management.
  2. Choose Add new for each room, and fill in:
    • Name, as it appears in the programme, for example "Hall A";
    • Capacity, the number of seats. The Agenda Builder warns when more people are expected than the room seats;
    • Screen format, for example 16:9. The slide check compares each speaker's slides with the screen of their room;
    • Show in Agenda, so that the room becomes a column of the grid;
    • Venue, if your event uses more than one building.
  3. Save.

Each room shown in the agenda becomes a column of the grid.

The Room fly-out, with Capacity, Screen format and Show in Agenda

See Configuring and Managing Venues and Rooms for every setting of a room.

Step 3: Set the hours of the grid

  1. Open the Agenda Builder, under Manage on the Content And Speakers page.
  2. In the menu, under Tools, open Agenda Settings and its tab General.
  3. Set Start time and Finish time: the first and the last hour the grid shows, in whole hours.
  4. Set Default session duration (minutes), the length a session takes when you place it, unless its presentation type says otherwise.
  5. Save.

The hours apply to every day and every room. If your first day starts at noon and the others at 8:00, set 8:00, and leave the morning of the first day empty.

Step 4: Add the breaks

  1. In the menu, open To place. Under the sessions, the tiles for breaks, new blocks and placeholders wait to be dragged.
  2. Drag a break onto the grid, at its time and in its room.
  3. Choose the break to open it: enter the Name, for example "Coffee break", and check Start and End. Tick Public if attendees should see it.
  4. To repeat the break on other days, use Repeat on days… in its menu.

A break sits in one room. A lunch for the whole congress needs a break in each room. Repeat on days… copies a break to other days, not to other rooms.

Step 5: Sketch the slots

There is no template of time slots. You draw the frame of the programme with the entries themselves:

Related articles